Andrew (G0RVM) wrote:
> MAS wrote:
>
>> Hi all,
>>
>> I have a Garmin 296 and a remote antenna that I want to mount about 40cm
>> from the GPS unit. The cable on the remote antenna is a good 2mts too
>> long so is it ok to just coil it up and tie it out of the way or does
>> coiling the cable cause interference ?
>>
>> Am I better of cutting the cable to the right length and fitting a new BNC
>> connector ?
>>
>> Cheers..
>
> Either would be just fine. However, if one end of the cable is moulded into
> the antenna, you may be better off just coiling the wire - hold it together
> with a couple of cable ties - in case you ever want to move it further away.
> Sods law and all that....
>
> Andrew
>
>
A shorter cable will always be better for signal strength, however the
original will have had the plug fitted properly (we hope). A poor DIY
job could well be worse. Unless you have problems I would leave it
alone. Just dont coil it too tightly (3 inch dia loops is fine) and
dont put it where the cable will get squeezed.